G83 peck drilling cycle
Posted by
mtd
on 2001-04-15 09:39:29 UTC
I am evaluating doing a retrofit on a manual bridgeport and
having Mitutoyo do it and going for the Millstar 3 package
that supports full 3 axis programs.
I have not given them a 3 axis program to check out
the surface contour abilities yet.
But I have been playing around with there 3 axis software.
My question is millstar 3 software does not support G83 a
peck drilling cycle in G code format it does support
G81 how can I work around this when I post my
cam program?
[Non-text portions of this message have been removed]
having Mitutoyo do it and going for the Millstar 3 package
that supports full 3 axis programs.
I have not given them a 3 axis program to check out
the surface contour abilities yet.
But I have been playing around with there 3 axis software.
My question is millstar 3 software does not support G83 a
peck drilling cycle in G code format it does support
G81 how can I work around this when I post my
cam program?
[Non-text portions of this message have been removed]