Re: [CAD_CAM_EDM_DRO] rapid G210 'overdrive' rates using logic on header blocks

The Ah Ha design group's RC500 drives drive those finned steppers at least
60 ipm from my experience, microstepping. But, three axi costs over
$2100.00

Tom E.

----- Original Message -----
From: Matt Shaver <mshaver@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Wednesday, April 18, 2001 1:27 AM
Subject: Re: [CAD_CAM_EDM_DRO] rapid G210 'overdrive' rates using logic on
header blocks


> Tim Goldstein wrote:
>
>
> > Don't know what that speed will be if you limit the drive to 80 V max,
but
> > with the stock drivers (they are something like 160 V drives) the
maximum
> > rapid was 25 ipm.
>
> Don't you mean 125ipm, or were the machines with the square profile
> finned motors really that slow?
>
> Matt
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>