Re: [CAD_CAM_EDM_DRO] Re: Small Injection molding unit?

----- Original Message -----
From: Smoke <gordonr@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Thursday, April 19, 2001 10:47 AM
Subject: Re: [CAD_CAM_EDM_DRO] Re: Small Injection molding unit?


> I'd have to agree about going overboard. He did build a nice machine
> though!
> I just got back from my trip to Missouri where I was able to visit with
Dan
> Eaton and see the unit he built based on Gingerys plans. I've got a few
> ideas already that will improve that design considerably without goig so
> ":overboard".
> It should be easy to build and not cost much .... prime factors to us
> hobbyists...no?
>
> I'll try to get something sketched up in the next week or three. At the
> moment I'm pretty swamped with paperwork and other commitments.
>
> Smoke
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>