Re: [CAD_CAM_EDM_DRO] High speed belts
Posted by
Joe Vicars
on 2001-04-20 06:11:33 UTC
My delta wood planer runs about that speed and it uses just an H series type timing belt. I also have a router offset attachment
that uses the same.
Should'nt be a problem.
Tim Goldstein wrote:
that uses the same.
Should'nt be a problem.
Tim Goldstein wrote:
> I am putting together a project that will have a 1 hp 10,000 rpm motor
> driving the spindle through a belt with it a reduction so the spindle it
> turning 9,000 rpms. Any suggestions as to what type of belt to use?
>
> Tim
> [Denver, CO]
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
Discussion Thread
wanliker@a...
2001-04-19 22:55:57 UTC
Re: [CAD_CAM_EDM_DRO] Check out http://www.users.qwest.net/~kmaxon/page/home....
Tim Goldstein
2001-04-19 23:06:11 UTC
High speed belts
Joe Vicars
2001-04-20 06:11:33 UTC
Re: [CAD_CAM_EDM_DRO] High speed belts