Re: [CAD_CAM_EDM_DRO] crank as hell
Posted by
Sven Peter, TAD S.A.
on 2001-04-20 17:46:36 UTC
Hello folks,
a off topic question.
For a actually working centrifuge (High frequency induction for metal
casting)
I shall put a new motor on that starts up much faster.
The 7 kg cross beam of 73 cm length needs with the original 250 watt
(1/3 hp)
normal single phase motor two turns to come on speed.
Result: The castings come out defective.
First I thought about to put a 1 or 2 hp three fase motor on it.
Are there other motor types that still have a better cranking at the
start up???
Sorry, but 95 percent of my daily bread experience is based on three
fase motors.
The rest is a closed book for me.
Thank you for any response.
Sven Peter
a off topic question.
For a actually working centrifuge (High frequency induction for metal
casting)
I shall put a new motor on that starts up much faster.
The 7 kg cross beam of 73 cm length needs with the original 250 watt
(1/3 hp)
normal single phase motor two turns to come on speed.
Result: The castings come out defective.
First I thought about to put a 1 or 2 hp three fase motor on it.
Are there other motor types that still have a better cranking at the
start up???
Sorry, but 95 percent of my daily bread experience is based on three
fase motors.
The rest is a closed book for me.
Thank you for any response.
Sven Peter
Discussion Thread
Sven Peter, TAD S.A.
2001-04-20 17:46:36 UTC
Re: [CAD_CAM_EDM_DRO] crank as hell
Rich D.
2001-04-20 18:52:46 UTC
Re: [CAD_CAM_EDM_DRO] crank as hell
Sven Peter, TAD S.A.
2001-04-20 19:13:32 UTC
Re: [CAD_CAM_EDM_DRO] crank as hell
Marcus & Eva
2001-04-20 20:39:13 UTC
Re: [CAD_CAM_EDM_DRO] crank as hell
R. T. Robbins
2001-04-20 20:51:10 UTC
Re: [CAD_CAM_EDM_DRO] crank as hell
Jon Elson
2001-04-20 22:35:53 UTC
Re: [CAD_CAM_EDM_DRO] crank as hell
Carey L. Culpepper
2001-04-21 07:12:15 UTC
Re: [CAD_CAM_EDM_DRO] crank as hell
Sven Peter, TAD S.A.
2001-04-21 09:57:50 UTC
Re: [CAD_CAM_EDM_DRO] crank as hell