Projects

Andrew:

Thank you for the hints about Rhino. I am trying to do things with
it, but it is much harder than I thought.
You had a few questions about my CAF :-)
Well, it was just some ideas to a program interface, and the main
thing was to have small jobs done, without entering G-codes
directly.

Dan:

Well, when I asked if anyone had a job for me, - I was thinking more
in terms of something that could pay my bills. I don't have a job
right now, and I just could like a trip to the States :-)

Nope, I am not much of a programmer - just an amateur, I think. I
have plenty of projects, so I don't know if I would have time for
it. But on the other hand, I plan to look into some of it, - so who
knows.

Bertho Boman:

You are right, - I just read your input on the "Hand Wheel" stuff.
I just hadn't read it in full, before I sent something more about
input ports.
( The reason - some use long lines, and I don't get them on the
printout. I have to read it again on the screen )

But, I may be wrong: I thought you could only use two parallel
boards ? So, I just sent a note on how to expand this. Else you
have to use other boards, - and I think it would be ok to use
something that is available to most.

//ARNE