Re: Re: Re: EMC spindle speed control

From: "Marty Escarcega" <escarcega@...>

<bas>

>Do I read right that these assignments are on the second parallel
>port? And have something to do with BRIDGEPORTIO?

If you are using steppers rather than the stg card, you will need to use a
second parport because one is taken up with step and direction signals.

Bridgeportio does send it's signals to the parport defined in the IO
section of the ini. So does tkio. But you could write a Tcl/Tk routine
that sends them somewhere else. An example of this would be a dedicated
digital IO card. Another might be a serial port connection to a pic,
stamp, tiger, etc.

HTH
Ray