Re: Stepper

1.6 VDC
Dan
-----Original Message-----
From: Ian Wright <Ian@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Thursday, September 16, 1999 2:33 AM
Subject: Re: [CAD_CAM_EDM_DRO] Stepper

>From: "Ian Wright" <Ian@...>
>
>Thanks Dan,
>
>It seems more powerful than I imagined. I thought when I looked at the
>tiddly little wires coming from it that it would only take half an amp or

so

>and be low powered. However, it has a flexible coupling on it which has
>driven a half-inch shaft and so I should have known better. Do you know

what

>voltage it was designed for - just as a matter of interest? Thanks,
>
>Ian
>
>----- Original Message -----
>From: Dan Mauch <dmauch@...>
>To: <CAD_CAM_EDM_DRO@onelist.com>
>Sent: 15 September 1999 20:34
>Subject: Re: [CAD_CAM_EDM_DRO] Stepper
>
>
>> From: "Dan Mauch" <dmauch@...>
>>
>> I have the data for the 2235d200-E037 which is 6wires 140 oz in nema23

200

>> spr 4.4a per phase.36 ohms
>
>
>Ian W. Wright
>Sheffield UK
>
>
>--------------------------- ONElist Sponsor ----------------------------
>
> GRAB THE GATOR! FREE SOFTWARE DOES ALL THE TYPING FOR YOU!
>Tired of filling out forms and remembering passwords? Gator fills in
>forms and passwords with just one click! Comes with $50 in free coupons!
> http://www.onelist.com/ad/gator1
>
>------------------------------------------------------------------------
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>For the FAQ, go to http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>