Re: [CAD_CAM_EDM_DRO] Z-Axis CNC Control of Grizzly Minimill
Posted by
wanliker@a...
on 2001-06-13 21:21:04 UTC
In a message dated 6/13/01 9:27:59 PM Mountain Daylight Time,
brucen@... writes:
<< Why can't you
just hook the stepper motor up to the original quill handle shaft
with a timing belt like the X and Y axes? >>
I think if you go and wiggle the quill handle, you will find your answer
rather quickly, there is a spur gear on the handle and a rack on the quill,
and there is simply too much backlash for accurate work. This is my opinion,
others will comment I am sure.
bill
brucen@... writes:
<< Why can't you
just hook the stepper motor up to the original quill handle shaft
with a timing belt like the X and Y axes? >>
I think if you go and wiggle the quill handle, you will find your answer
rather quickly, there is a spur gear on the handle and a rack on the quill,
and there is simply too much backlash for accurate work. This is my opinion,
others will comment I am sure.
bill
Discussion Thread
brucen@a...
2001-06-13 13:22:10 UTC
Z-Axis CNC Control of Grizzly Minimill
Jon Elson
2001-06-13 14:55:55 UTC
Re: [CAD_CAM_EDM_DRO] Z-Axis CNC Control of Grizzly Minimill
wanliker@a...
2001-06-13 21:21:04 UTC
Re: [CAD_CAM_EDM_DRO] Z-Axis CNC Control of Grizzly Minimill
Tim Goldstein
2001-06-13 21:43:56 UTC
FA, Bridgeport NEMA 42 stepper motor
Tom Eldredge
2001-06-14 10:34:33 UTC
Re: [CAD_CAM_EDM_DRO] FA, Bridgeport NEMA 42 stepper motor
Tim Goldstein
2001-06-14 10:56:19 UTC
RE: [CAD_CAM_EDM_DRO] FA, Bridgeport NEMA 42 stepper motor