Shameless Plug!
Posted by
Doug Harrison
on 2001-07-07 20:32:15 UTC
Greetings one and all;
I just finished initial testing of WB8, the long promised interface card for CNCpro. It works.
WB8 is the eighth revision of my original Wonderboard idea. It has buffered step/direction outputs, optoisolated limits and control outputs, enable/disable for Gecko G3X0 drives and fault sensing for the same.
You can look at WB8 at www.ps-products.com . Comments are welcome.
Many thanks to Jon Elson, Tom Eldridge and all of you who contributed ideas for this project.
Doug
[Non-text portions of this message have been removed]
I just finished initial testing of WB8, the long promised interface card for CNCpro. It works.
WB8 is the eighth revision of my original Wonderboard idea. It has buffered step/direction outputs, optoisolated limits and control outputs, enable/disable for Gecko G3X0 drives and fault sensing for the same.
You can look at WB8 at www.ps-products.com . Comments are welcome.
Many thanks to Jon Elson, Tom Eldridge and all of you who contributed ideas for this project.
Doug
[Non-text portions of this message have been removed]