CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Surplus sources for 90-vdc motors?

Posted by Doug Harrison
on 2001-07-11 13:34:25 UTC
How many do you need? I have ten or so, most of which just need brushes.

Doug


----- Original Message -----
From: Ron Yost <musik@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, July 10, 2001 11:13 AM
Subject: [CAD_CAM_EDM_DRO] Surplus sources for 90-vdc motors?


> A bit off-topic perhaps. Anyone know a good source for surplus
> 1/4 to 1/3 hp., 90-vdc motors?
>
> These aren't exactly for CNC use, but are going into a self-
> built 'winder' for 10,000 ft. reels of 35mm movie film. I collect
> and show 35mm films as one of my 'hobbies' (obsessions?).
>
> Thanks a bunch!
> Ron Yost, Paso Robles, Calif.
>
>
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>

Discussion Thread

Eric Keller 2001-07-10 17:33:43 UTC I just bought a robot controller Ron Yost 2001-07-10 19:10:57 UTC Surplus sources for 90-vdc motors? Jon Elson 2001-07-10 20:45:34 UTC Re: [CAD_CAM_EDM_DRO] I just bought a robot controller van halcomb 2001-07-10 21:56:54 UTC Re: [CAD_CAM_EDM_DRO] I just bought a robot controller van halcomb 2001-07-10 21:58:06 UTC Re: [CAD_CAM_EDM_DRO] I just bought a robot controller Doug Harrison 2001-07-11 13:34:25 UTC Re: [CAD_CAM_EDM_DRO] Surplus sources for 90-vdc motors?