CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] New drives

Posted by diazden
on 2001-07-12 19:34:53 UTC
Yes they are designed by my friend Graham; I have seen
them work with a rare earth 2.amps nema 23 motors
I have 4 and combined with the constant current drivers
that he also designed I measured 280 rpm and this motors
have a 7/8 diameter pulley and I could not stop the motors at that speed and
burned my fingers, the imput
voltage is max 32v and when I was trying them the voltage was 30v , I was
waiting to see if the constant current drivers would work with the former
driver cards
before contacting the list about them
regards
mariano

----- Original Message -----
From: <mabw@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, July 13, 2001 8:08 AM
Subject: [CAD_CAM_EDM_DRO] New drives


> HI! all,
> Noticed some new drives and current control device on
> www.oatleyelectronics.com no connection with this but
> thought you might like to have alook , what with our weak aus. dollar
> the prices are cheap for you guys . Any thoughts about the current
> control device , got one on the way to try out( don't know when!)
> cheers
> Mark
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>

Discussion Thread

mabw@b... 2001-07-12 15:09:13 UTC New drives diazden 2001-07-12 19:34:53 UTC Re: [CAD_CAM_EDM_DRO] New drives Scott M. Thomas 2001-07-13 11:10:08 UTC RE: [CAD_CAM_EDM_DRO] New drives diazden 2001-07-15 03:54:54 UTC Re: [CAD_CAM_EDM_DRO] New drives