Re: [CAD_CAM_EDM_DRO] DC Motor types
Posted by
A&K ERWOOD
on 2001-07-24 14:11:06 UTC
Jon,
Thanks for getting back to me.
By AC Leg I mean the AC terminal of the Bridge. I try a little artwork.
------------------------------------------
------------------ Power (+)
/ \
/ \
/ \
- { - + } --------------------- To
Field
- \ /
- \ /
- \ /
- ------------------------------------------
----------------- To Arm
----------------------------------------------- To Field
Power
(-)----------------------------------------------- To Arm
I hope this explains it a bit better. If the art is readable.
Andrew
Thanks for getting back to me.
By AC Leg I mean the AC terminal of the Bridge. I try a little artwork.
------------------------------------------
------------------ Power (+)
/ \
/ \
/ \
- { - + } --------------------- To
Field
- \ /
- \ /
- \ /
- ------------------------------------------
----------------- To Arm
----------------------------------------------- To Field
Power
(-)----------------------------------------------- To Arm
I hope this explains it a bit better. If the art is readable.
Andrew
>I can't even figure out what you've done here. You should not need any
>rectifier or other component. Depending on the DC supply voltage for the
>servo amp, you might need a series resistor to provide the correct voltage
>to the field winding. Wire it up as I mention above and see how it works.
>(I don't know what you mean by AC leg - do you mean the motor output
>terminals of the servo amp?)
>
>Jon
>
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>
Discussion Thread
a_k@a...
2001-07-24 04:17:35 UTC
DC Motor types
Jon Elson
2001-07-24 11:28:15 UTC
Re: [CAD_CAM_EDM_DRO] DC Motor types
A&K ERWOOD
2001-07-24 14:11:06 UTC
Re: [CAD_CAM_EDM_DRO] DC Motor types
Jon Elson
2001-07-24 22:31:05 UTC
Re: [CAD_CAM_EDM_DRO] DC Motor types