Question, dimensions for N23 steppers
Posted by
Jon Anderson
on 2001-08-04 09:55:19 UTC
I'm working on a much revised thrust plate setup for the MaxNC mills.
Trying to compact things as much as possible, I designed around the
couple motors I have laying around here, some PacSci motors.
I measure the shaft extension from the mounting face at about .800, and
have designed accordingly. Before I commit anything to metal, wanted to
ask, is anyone aware of any commonly found N23 motors with shafts that
extend beyond this? I'd think that adhering to a standard would insure
this IS the standard, but standards just don't always seem to be, well,
standard...
Thanks,
Jon A.
Trying to compact things as much as possible, I designed around the
couple motors I have laying around here, some PacSci motors.
I measure the shaft extension from the mounting face at about .800, and
have designed accordingly. Before I commit anything to metal, wanted to
ask, is anyone aware of any commonly found N23 motors with shafts that
extend beyond this? I'd think that adhering to a standard would insure
this IS the standard, but standards just don't always seem to be, well,
standard...
Thanks,
Jon A.