Grizzly, spindle head, etc
Posted by
David E. Queen
on 2001-08-08 05:02:37 UTC
I thought the G8750 had only 4 inch x 12 travel, the G5757 has 5x8. I think
I could use the extra inch more than the wider x travel.
re: "This project was brought on by Nansel's "Heavy Iron" article in Nuts
& Volts a while back."
Missed it, I will have to check that one out.
re: "Anybody have an idea for a cheap spindle of some sort?"
The Taig spindle in the Lathe is the same one Taig uses on their mill, which
is
pretty beefy. I think you can buy one from
http://www.cartertools.com/nfhome.html
for about $65-70
I could use the extra inch more than the wider x travel.
re: "This project was brought on by Nansel's "Heavy Iron" article in Nuts
& Volts a while back."
Missed it, I will have to check that one out.
re: "Anybody have an idea for a cheap spindle of some sort?"
The Taig spindle in the Lathe is the same one Taig uses on their mill, which
is
pretty beefy. I think you can buy one from
http://www.cartertools.com/nfhome.html
for about $65-70