What is EMC??
Posted by
riet91@y...
on 2001-08-09 02:40:49 UTC
It's sound stupid but I have some basic questions ,is it a G code
interpreter? Can this be used for Retrofitting? What output it
delivers for drives of XYZ axis ?I have the impression that it uses
some motion control card like the one from Servo To Go Inc please
answer these questions.
interpreter? Can this be used for Retrofitting? What output it
delivers for drives of XYZ axis ?I have the impression that it uses
some motion control card like the one from Servo To Go Inc please
answer these questions.