Re: servos
Posted by
Dean Franks
on 1999-09-26 10:49:31 UTC
Ian,
They would slow it down way to much (at least with standard opto-isolators).
I think it would be a better idea to isolate the digital PWM signal, and
carefully shield the encoder cabling. That will isolate the interface from
the 'power' side of things. I would also use an ISA IDE controller, either
set for a non-standard address or with one of the MB controllers disabled.
I am building a prototype controller inside a metal drive nest module. That
will allow me to get power and ide signals from the machine for the digital
side and provide fan cooling for the controller.
Dean
They would slow it down way to much (at least with standard opto-isolators).
I think it would be a better idea to isolate the digital PWM signal, and
carefully shield the encoder cabling. That will isolate the interface from
the 'power' side of things. I would also use an ISA IDE controller, either
set for a non-standard address or with one of the MB controllers disabled.
I am building a prototype controller inside a metal drive nest module. That
will allow me to get power and ide signals from the machine for the digital
side and provide fan cooling for the controller.
Dean
----- Original Message -----
From: Ian Wright <Ian@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Saturday, September 25, 1999 1:10 PM
Subject: Re: [CAD_CAM_EDM_DRO] servos
> From: "Ian Wright" <Ian@...>
>
> Hi Dean,
>
> I like this idea - the only reservation I would have is that it would come
> perilously close to the heart of the machine. Do you think it could be
> designed to incorporate opto isolators or would they slow it down too
much?
>
> Ian
> --
> Ian W. Wright
> Sheffield UK
>
Discussion Thread
Jon Elson
1999-09-24 12:26:39 UTC
Re: servos
David Howland
1999-09-24 13:38:22 UTC
RE: servos
Jon Elson
1999-09-24 15:30:00 UTC
Re: servos
David Howland
1999-09-24 16:49:04 UTC
RE: servos
Dean Franks
1999-09-24 18:51:30 UTC
Re: servos
Ian Wright
1999-09-25 13:10:25 UTC
Re: servos
Dean Franks
1999-09-26 10:49:31 UTC
Re: servos
David Howland
1999-09-27 11:48:48 UTC
RE: servos
Dean Franks
1999-09-27 12:24:13 UTC
Re: servos
Paul Corner
1999-09-27 13:17:45 UTC
RE: servos
David Howland
1999-09-27 15:09:54 UTC
RE: servos
David Howland
1999-09-27 15:33:42 UTC
RE: servos