Re: [CAD_CAM_EDM_DRO] DNC?!

Ivan,

A post processor is used to output code for a given machine or a similar
group of machines that use the same G code. Before you start your output,
you need to select the proper post.

In many cases you would put the file to a disk and then use another program
to send the file to the machine. In all cases you would need to select the
proper post to create the correct code.

DNC is just a program that allows you to send files from your disk to a
machine.

In all cases you will need to specify a specific Postprocessor.

Bob

----- Original Message -----
From: "Ivan Bojikov" <linivan@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, August 10, 2001 6:28 PM
Subject: [CAD_CAM_EDM_DRO] DNC?!


> Hi There,
> A question is bothering me:
> A CAM Program sends G code to a specific machine (tool) trough a
Postprocessor for this machine or DNC for any machine.
> What is the advantage and disadvantage of using DNC versus the specific
Postprocessor?
> Regards, Ivan
>
>
>
> [Non-text portions of this message have been removed]
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>