Bridgeport Rotary table
Posted by
ace@d...
on 2001-08-17 19:41:59 UTC
Hello.
I picked up a rotary table at an auction that has a stepper motor
that looks exactly like the steppers on my BOSS 5. It has a 7 pin
connector on the cable. My BOSS 5 is bone stock with the exception of
the way I load programs.( thru a "Behind the reader" board ) I have a
couple of connectors on the front of the machine at the bottom right
hand corner and was told they were an option for this purpose. Does
any one know anything about this matter. I want to mount a fixture on
this jewel to turn my parts so I can machine all the sides in one
setup. All replies are appreciated.
John
I picked up a rotary table at an auction that has a stepper motor
that looks exactly like the steppers on my BOSS 5. It has a 7 pin
connector on the cable. My BOSS 5 is bone stock with the exception of
the way I load programs.( thru a "Behind the reader" board ) I have a
couple of connectors on the front of the machine at the bottom right
hand corner and was told they were an option for this purpose. Does
any one know anything about this matter. I want to mount a fixture on
this jewel to turn my parts so I can machine all the sides in one
setup. All replies are appreciated.
John