Master5 , new version
Posted by
Art Fenerty
on 2001-08-24 20:46:13 UTC
(sorry, previous post had wrong message line.)
Hi:
The registered version of Master5 has just been updated to the 2.00ATP
Beta version. Please backup your old version before using it just in case.
This version is cutting most jobs up to 6 times faster than previous
versions. It now emulates EMC in terms of how it does its trajectory
planning , velocity determination, and line blending functions. Smooth
ramped circles are now installed, in fact a circle will cut just as fast as
a straight line.
Be carefull and watch for bugs, it is not fully tested (can anything be?).
Tool length offset is not yet activated but everything else is except for
re-starting at an arbitrary line number. These will be turned on in a few
days..
The demo will be updated in a couple days as well.
Good luck, and please let me know how it goes,
Art
[Non-text portions of this message have been removed]
Hi:
The registered version of Master5 has just been updated to the 2.00ATP
Beta version. Please backup your old version before using it just in case.
This version is cutting most jobs up to 6 times faster than previous
versions. It now emulates EMC in terms of how it does its trajectory
planning , velocity determination, and line blending functions. Smooth
ramped circles are now installed, in fact a circle will cut just as fast as
a straight line.
Be carefull and watch for bugs, it is not fully tested (can anything be?).
Tool length offset is not yet activated but everything else is except for
re-starting at an arbitrary line number. These will be turned on in a few
days..
The demo will be updated in a couple days as well.
Good luck, and please let me know how it goes,
Art
[Non-text portions of this message have been removed]