Set Coordinates Tcl
Posted by
Ethan Vos
on 2001-08-31 04:15:41 UTC
I'm really starting to have fun with this.
Questions about the Set Coordinates Tcl in the 801bin.
1. What do I need to change to get the cursor to the end of the zeros
(0.0000) rather than at the beginning?
2. What other parameters can I use (it starts with 5221) and where in the
tcl do I make the change? I tried changing the 5221 at the end of the
program to 1000, but the tcl wouldn't work. I need to make a Tcl to input
data into the variable table.
3. I have changed the setaxis to "2" instead of to read from the .ini file.
I labeled them "Shim Adjust" and Excessive Wear" which I need to correspond
to axis X and A. X is working OK, but I the 2nd axis (A) is updating the Y
field. What do I need to do to change that?
4. Where does the data come from that the Tkemc reads when it displays the
axis offsets? I can't figure out why when I enter in 1.0 on the
Set_Coordinates the display changes by .0394. I'm using G20 (I think) and
the .ini file has been changed from "auto" to "inches"
Thanks.
Ethan
Questions about the Set Coordinates Tcl in the 801bin.
1. What do I need to change to get the cursor to the end of the zeros
(0.0000) rather than at the beginning?
2. What other parameters can I use (it starts with 5221) and where in the
tcl do I make the change? I tried changing the 5221 at the end of the
program to 1000, but the tcl wouldn't work. I need to make a Tcl to input
data into the variable table.
3. I have changed the setaxis to "2" instead of to read from the .ini file.
I labeled them "Shim Adjust" and Excessive Wear" which I need to correspond
to axis X and A. X is working OK, but I the 2nd axis (A) is updating the Y
field. What do I need to do to change that?
4. Where does the data come from that the Tkemc reads when it displays the
axis offsets? I can't figure out why when I enter in 1.0 on the
Set_Coordinates the display changes by .0394. I'm using G20 (I think) and
the .ini file has been changed from "auto" to "inches"
Thanks.
Ethan
Discussion Thread
Ethan Vos
2001-08-31 04:15:41 UTC
Set Coordinates Tcl
Ethan Vos
2001-08-31 04:24:55 UTC
RE: [CAD_CAM_EDM_DRO] Set Coordinates Tcl
Jon Elson
2001-08-31 10:47:25 UTC
Re: [CAD_CAM_EDM_DRO] Set Coordinates Tcl