Re: Simple Parallel Port controller
Posted by
sariddle@l...
on 2001-09-02 08:32:42 UTC
--- In CAD_CAM_EDM_DRO@y..., Jon Elson <elson@p...> wrote:
appreciate a wiring schematic if you have one.
Thanks
Scott
> Scott Riddle wrote:and on a
>
> > I am looking for some help to use my parallel port to turn off
> > small relay switch. The device I want to control will shut offautomatically
> > after 1 cycle but it needs a 1 second ON switch to activate it.What I am
> > doing is turning a small motor on and it will turn one revolutionand then
> > stop when the cam lobe on the pulley hits the switch lever tostop it. I
> > need the computer to turn the relay on to start the motor moving.The motor
> > is just a plain motor 12V not a stepper or servo. I will have thefinal
> > drive slowed way down with a pulley so the switch cycle will take3-4
> > seconds. I have seen some simple controller boards for smallservo motors
> > for about $50 but All I need is a Off and ON switch. I wouldappreciate any
> > help.instance.
>
> You can get DC solid state relays. Digi-Key sells them, for
> You can connect the SSR to the parallel port directly. It worksbest
> if you supply +5 V from a spare disk drive power connector, or fromthe
> game port (pins 1,8,9, and 15 are +5 V). Use the parallel port bitto
> drive the pin you are using to ground to turn on the LED in the SSR.Can you give me more info on how to use the game port? I would
>
> Jon
appreciate a wiring schematic if you have one.
Thanks
Scott
Discussion Thread
Scott Riddle
2001-09-01 08:47:13 UTC
Simple Parallel Port controller
Eric Keller
2001-09-01 09:23:36 UTC
Re: [CAD_CAM_EDM_DRO] Simple Parallel Port controller
Jon Elson
2001-09-01 10:29:44 UTC
Re: [CAD_CAM_EDM_DRO] Simple Parallel Port controller
Alan Marconett KM6VV
2001-09-01 11:56:24 UTC
Re: [CAD_CAM_EDM_DRO] Simple Parallel Port controller
JanRwl@A...
2001-09-01 13:18:24 UTC
Re: [CAD_CAM_EDM_DRO] Simple Parallel Port controller
wayne_j_hill@y...
2001-09-01 17:50:16 UTC
Re: Simple Parallel Port controller
sariddle@l...
2001-09-02 08:27:36 UTC
Re: Simple Parallel Port controller
sariddle@l...
2001-09-02 08:30:16 UTC
Re: Simple Parallel Port controller
sariddle@l...
2001-09-02 08:32:42 UTC
Re: Simple Parallel Port controller
JanRwl@A...
2001-09-02 12:35:19 UTC
Re: [CAD_CAM_EDM_DRO] Re: Simple Parallel Port controller
JanRwl@A...
2001-09-02 12:44:53 UTC
Re: [CAD_CAM_EDM_DRO] Re: Simple Parallel Port controller