Re: [CAD_CAM_EDM_DRO] Tom Kulaga's DRO+ site

I also wrote a Visual Basic program, for 3 axis', and
Paul-Ernest Levesque and Frank Papineau have worked
to up it to 4 axis'. Source code is there and it works fine,
but there are not a lot of features. It will do inches or mm,
and you can reset it to any value you wish, but no backlash
compensation is there. Feel free to use it as you see fit.
It's been awhile, but I think it is set up for 640X480 so you
can use it with an old 486 and a basic VGA mointor running
windows 95. Find it here.
http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/VB-DRO/

Bill

----- Original Message -----
From: "Tim" <timg@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, September 21, 2001 11:02 AM
Subject: RE: [CAD_CAM_EDM_DRO] Tom Kulaga's DRO+ site


> Don't know about the site, but Tom's complete design and the software is
> available from Camtronics as a kit or a complete assembly. I also have
> some PC code to access the card on my site.
>
> Tim
> [Denver, CO]
> http://www.KTMarketing.com/CNC.html
>
> > -----Original Message-----
> >
> >
> > Anyone know the URL for Tom Kulaga's DRO+ site. The only one
> > I know is www.mcs.net/~kulaga/dro.html and it's no longer
> > working. I am
> > considering building a DRO using USDigital's linear strips (using X4
> > can get 1440 CPI) and sensors. I'm aware of Steve Lindsay's DRO
> > software and was wondering what Tom Kulaga has available. I'm not
> > sure yet if I want to use a PC or if I want to write PIC software and
> > make the DRO standalone.
> >
> > I'm open to any suggestions on building DROs.
> >
> >
> > Addresses:
> > FAQ: http://www.ktmarketing.com/faq.html
> > FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>