Re: Backlash Fixes
Posted by
ym_wong@p...
on 2001-10-11 14:22:20 UTC
--- In CAD_CAM_EDM_DRO@y..., dkowalcz@d... wrote:
relation to the carriage & cross-slide, i.e. perhaps a bit further
away so I can see the "bigger picture". A closeup of the assembly
would also be nice as well, however.
How much force is the spring applying to the cross-slide, do you have
a guess? I assume it must be greater than what the cross-slide
experiences during cutting. I wonder how much that would be? Perhaps
a better question is how did you pick your spring?
Thanks.
ym
> It's a small aluminum lever with its fulcrum mounted on an "L"the
> shaped bracket on the carriage. One side is pulled by a strong
> tension spring.
>
> The other side is attached to the cross-slide by a short cable.
>
> Why so complicated? Well, regular tension springs don't deliver
> constant force over their span. Instead of using 3" of travel on
> spring this gadget makes it 1/2" through the lever, so the force onmy
> the slide is more consistent.
>
> If you need a better picture, I can take one when I get home as
> lathe is apart right now for maintenance.Yes, a picture or two would be great. May be one showing it in
>
> Dave Kowalczyk
> Seattle WA
relation to the carriage & cross-slide, i.e. perhaps a bit further
away so I can see the "bigger picture". A closeup of the assembly
would also be nice as well, however.
How much force is the spring applying to the cross-slide, do you have
a guess? I assume it must be greater than what the cross-slide
experiences during cutting. I wonder how much that would be? Perhaps
a better question is how did you pick your spring?
Thanks.
ym
Discussion Thread
ccs@m...
2001-10-09 07:41:56 UTC
Backlash Fixes
Smoke
2001-10-09 09:26:40 UTC
Re: [CAD_CAM_EDM_DRO] Backlash Fixes
Jon Elson
2001-10-09 11:27:06 UTC
Re: [CAD_CAM_EDM_DRO] Backlash Fixes
dkowalcz@d...
2001-10-09 19:33:55 UTC
Re: Backlash Fixes
ym_wong@p...
2001-10-10 23:16:30 UTC
Re: Backlash Fixes
dkowalcz@d...
2001-10-11 11:25:02 UTC
Re: Backlash Fixes
ym_wong@p...
2001-10-11 14:22:20 UTC
Re: Backlash Fixes
dkowalcz@d...
2001-10-11 22:08:44 UTC
Re: Backlash Fixes
Ward M.
2001-10-12 00:55:42 UTC
RE: [CAD_CAM_EDM_DRO] Re: Backlash Fixes