Re: 4-axis control
Posted by
Jon Anderson
on 1999-10-12 12:44:08 UTC
Fred Proctor wrote:
commands into the 6 axis' needed for hexapod control? Not that I'd rush
to build one right away, but a hexapod would sure make a great "Gee
Whiz" project when I have the time.
Jon
> The stepper motor interface can handle 6 axes (this is what IAre you saying that EMC is already internally capable of translating XYZ
> used for the hexapod) so that's done.
commands into the 6 axis' needed for hexapod control? Not that I'd rush
to build one right away, but a hexapod would sure make a great "Gee
Whiz" project when I have the time.
Jon
Discussion Thread
Fred Proctor
1999-10-12 11:25:58 UTC
4-axis control
Jon Elson
1999-10-12 12:48:51 UTC
Re: 4-axis control
Jon Anderson
1999-10-12 12:44:08 UTC
Re: 4-axis control
Andrew Werby
1999-10-12 05:36:02 UTC
Re: 4-axis control
Brian Register
1999-10-12 14:55:54 UTC
Re: 4-axis control
Dan Falck
1999-10-12 17:01:55 UTC
Re: 4-axis control
Jon Elson
1999-10-12 22:57:49 UTC
Re: 4-axis control
Ian Wright
1999-10-13 11:01:44 UTC
Re: 4-axis control
Jon Elson
1999-10-13 16:21:22 UTC
Re: 4-axis control