CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: need some gear boxes

on 2001-10-26 09:27:23 UTC
If you want to go the grinder route check out eBay
1652036494. I use two of these for a driveway gate
opener with good sucess.

Pat
--- carlcnc@... wrote:
> I have considered that but need to make sure any
> backlash is the
> same in both boxes. These will be driving twin
> screws on a gantry.
> Thanks, I will check it out
>
> Carl
>
> -- In CAD_CAM_EDM_DRO@y..., vrsculptor@h... wrote:
> > Carl,
> > I saw someone using the gear box from a cheap
> harbor freight right
> > angle grinders in a pretty high stress
> environment. Northern Tool
> has
> > some for around $20 each.
> >
> > Roger
> >
> > --- In CAD_CAM_EDM_DRO@y..., carlcnc@e... wrote:
> > > I need a pair of decent gear bxes.right
> angle,3:1,to 7.5:1 ratios
> > > would work best.
> > > Anyone have such critters available?
> > >
> > > Carl Bruce
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES:
> http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe:
> CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe:
> CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com,
> wanliker@...
> Moderator: jmelson@...
> timg@... [Moderator]
> URL to this page:
> http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to
> http://docs.yahoo.com/info/terms/
>
>


__________________________________________________
Do You Yahoo!?
Make a great connection at Yahoo! Personals.
http://personals.yahoo.com

Discussion Thread

carlcnc@e... 2001-10-26 06:37:44 UTC need some gear boxes vrsculptor@h... 2001-10-26 08:11:29 UTC Re: need some gear boxes carlcnc@e... 2001-10-26 08:22:57 UTC Re: need some gear boxes Smoke 2001-10-26 08:37:15 UTC Re: [CAD_CAM_EDM_DRO] need some gear boxes Pat Reitelbach 2001-10-26 09:27:23 UTC Re: [CAD_CAM_EDM_DRO] Re: need some gear boxes Scott 2001-10-26 09:34:50 UTC Re: [CAD_CAM_EDM_DRO] Re: need some gear boxes