Re: [CAD_CAM_EDM_DRO] DRO kit
Posted by
William Scalione
on 2001-11-14 08:07:17 UTC
Jake,
Dan Mauch, who's on this group who sells a kit for a circuit board
that allows input of encoder quadrature signals for up to 4 axis'.
It's an ISA board that will run on an old computer which is used
for the display. There is DOS software available as well as a
basic VB program available in the files section of this group.
The source code if available if you wish to modify it. Most people
have been getting their encoders surplus or you can get them
form a place called US Digital at a reasonable price. Thats all
you need.
Encoders - www.usdigital.com
Interface Board - http://www.seanet.com/~dmauch/
Dan Mauch, who's on this group who sells a kit for a circuit board
that allows input of encoder quadrature signals for up to 4 axis'.
It's an ISA board that will run on an old computer which is used
for the display. There is DOS software available as well as a
basic VB program available in the files section of this group.
The source code if available if you wish to modify it. Most people
have been getting their encoders surplus or you can get them
form a place called US Digital at a reasonable price. Thats all
you need.
Encoders - www.usdigital.com
Interface Board - http://www.seanet.com/~dmauch/
----- Original Message -----
From: "James (jake)" <jjtjr@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Wednesday, November 14, 2001 9:37 AM
Subject: [CAD_CAM_EDM_DRO] DRO kit
> Does anyone know where I can get a 3 axis dro kit or schmatic of dro
> that I can built for a bridge mill .
> Jake
>
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
Discussion Thread
James (jake)
2001-11-14 07:38:01 UTC
DRO kit
William Scalione
2001-11-14 08:07:17 UTC
Re: [CAD_CAM_EDM_DRO] DRO kit
Alan Marconett KM6VV
2001-11-14 11:34:30 UTC
Re: [CAD_CAM_EDM_DRO] DRO kit