stuff to sell
Posted by
egroup@d...
on 2001-11-15 11:59:40 UTC
Well folks, after some time of dreaming about putting together my own
CNC, I realized I won't have the time and need the money.
So I'm selling some accumulated stuff I accumulated in this quest:
3 ball screws, dual circuit precision ground, used, bought from Bill
Griffin. About 34" long.
4 2500 count/rev encoders, heavy duty
3 pacsci low intertia servo motors, From C&H Sales (were 79.00ea)
1 12x12 troyke xy table without cranks or screws. The ways and gibs
are good. Travel is 10" or so in each axis. Heavy.
1 16" travel linear slide, heavy duty, with ball screw about 7-
1/2x8x1/2 sliding table. 75lbs or so.
1 6.5' travel linear slide, heavy duty, with ball screw
3 8x8x6 heavy slotted machined angle plates
misc other stuff, including some steppers, stepper driver board for 3
axis, some linear encoders (unknown if working) etc etc.
I'll have a better more descriptive list in a day or two, but want to
know if there is any interest in the above and like items.
if no interest here, I'll post on ebay. Maybe I should anyway, with
pictures etc.
Since a lot of this is heavy, I would rather have it picked up in the
northern LA area.
I also have a 7x10 minilathe with some mods, I might be willing to
sell. Along with a Griz mini-mill mid way into some mods.
Michael
CNC, I realized I won't have the time and need the money.
So I'm selling some accumulated stuff I accumulated in this quest:
3 ball screws, dual circuit precision ground, used, bought from Bill
Griffin. About 34" long.
4 2500 count/rev encoders, heavy duty
3 pacsci low intertia servo motors, From C&H Sales (were 79.00ea)
1 12x12 troyke xy table without cranks or screws. The ways and gibs
are good. Travel is 10" or so in each axis. Heavy.
1 16" travel linear slide, heavy duty, with ball screw about 7-
1/2x8x1/2 sliding table. 75lbs or so.
1 6.5' travel linear slide, heavy duty, with ball screw
3 8x8x6 heavy slotted machined angle plates
misc other stuff, including some steppers, stepper driver board for 3
axis, some linear encoders (unknown if working) etc etc.
I'll have a better more descriptive list in a day or two, but want to
know if there is any interest in the above and like items.
if no interest here, I'll post on ebay. Maybe I should anyway, with
pictures etc.
Since a lot of this is heavy, I would rather have it picked up in the
northern LA area.
I also have a 7x10 minilathe with some mods, I might be willing to
sell. Along with a Griz mini-mill mid way into some mods.
Michael
Discussion Thread
egroup@d...
2001-11-15 11:59:40 UTC
stuff to sell
Ed Fanta
2001-11-15 12:17:40 UTC
Re: [CAD_CAM_EDM_DRO] stuff to sell