Re mounts and belt drives, was Re: Camtronics

Hi Hugh,

Very nice motor mounts and timing belt drives! And I'm sure you're
going to work on the controller packaging! ;>)

Just kidding! Makes me itch to figure out mounts and belt drives for my
RF-31 mill!

For those looking for you, this is the complete URL:

http://internet.oit.edu/~currinh/cnc/cnc.html

Alan KM6VV


currinh@... wrote:

>
> Tim, et al:
>
> Your note pushed me over the edge, I put together a temporary web page
> for my cnc retrofit in progress. It is at:
>
> internet.oit.edu/~currinh/cnc/cnc.html
>
> I probably didn't shrink the pictures enough so it may be slow loading.
>
> But the reason Tim's e-mail prompted me is his mention of heat sinks for
> the Camtronic 5A boards. I used surplus heat sinks from C and H Sales
> Co. They are part number HD9853 at $2.25 each. They can be seen on this
> temporary web site. When I put the drives into a permanent box I put one
> large muffin fan blowing over all three boards. They seem to run very
> cool.
>
> Just FYI. :-)
>
> Hugh Currin
> Klamath Falls, OR
>
> P.S. The page is temporary, link and/or bookmark at your own risk.
> I'll have a permanent page up pretty soon. :-)
>