G2/3 to G1 conversion
Posted by
mark
on 2001-11-16 05:49:04 UTC
MOST CAD programs I've looked at have an EXPLODE or similar
command. Sometimes it's convert to polyline or spline.
And for those that are interested, ACE converter from Yeager
doesn't like some DXFs - have to look for the LAYER lines in the
dxf text and remove the text starting with that word until the next
CAPITALIZED word, which you keep, of course...
Be careful of layers - might be best to make sure you do all your cad
work on ONE layer for this reason alone. /mark
command. Sometimes it's convert to polyline or spline.
And for those that are interested, ACE converter from Yeager
doesn't like some DXFs - have to look for the LAYER lines in the
dxf text and remove the text starting with that word until the next
CAPITALIZED word, which you keep, of course...
Be careful of layers - might be best to make sure you do all your cad
work on ONE layer for this reason alone. /mark