Re: [CAD_CAM_EDM_DRO] Using a CNC Mill for Plasma Cutting

Roger,

From the comments that I have seen here in the past it does not sound like
a good idea.

Bob
www.campbelldesigns.com

----- Original Message -----
From: <vrsculptor@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Wednesday, November 28, 2001 4:27 PM
Subject: [CAD_CAM_EDM_DRO] Using a CNC Mill for Plasma Cutting


> I was wondering if anyone is using a CNC mill as a gantry for plasma
> cutting? Does this sound like a good or bad idea? Anything to watch
> out for? Even a smaller mill could do some useful stuff.
>
> Roger
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>