CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Sizing Rectifiers

Posted by Krahabors
on 2001-12-03 00:29:37 UTC
> ultimate load is resistive (arc welding). What amperage rating should
> the diodes have? Even at full output each diode doesn't feel the
> entire current all the time--right?

But your diodes will be burned by peak current not average. So just choose
diodes with the maximum current larger then your maximum welding current.

>
> I have checked some authoritative sources, e.g. Motorola Rectifier
> Applications Handbook, but wasn't entirely sure of what I was reading.

That Handbook is excellent.

KPL

Discussion Thread

jmw@c... 2001-11-30 20:07:38 UTC Sizing Rectifiers Bill Vance 2001-11-30 21:31:18 UTC Re: [CAD_CAM_EDM_DRO] Sizing Rectifiers Jon Elson 2001-11-30 22:09:00 UTC Re: [CAD_CAM_EDM_DRO] Sizing Rectifiers Peter Seddon 2001-12-01 02:22:21 UTC Re: [CAD_CAM_EDM_DRO] Sizing Rectifiers Fitch R. Williams 2001-12-01 08:21:17 UTC Re: [CAD_CAM_EDM_DRO] Sizing Rectifiers Jon Elson 2001-12-01 19:30:34 UTC Re: [CAD_CAM_EDM_DRO] Sizing Rectifiers Bill Vance 2001-12-01 20:25:49 UTC Re: [CAD_CAM_EDM_DRO] Sizing Rectifiers JanRwl@A... 2001-12-02 15:48:44 UTC Re: [CAD_CAM_EDM_DRO] Sizing Rectifiers JanRwl@A... 2001-12-02 16:01:05 UTC Re: [CAD_CAM_EDM_DRO] Sizing Rectifiers Bill Vance 2001-12-02 23:03:41 UTC Re: [CAD_CAM_EDM_DRO] Sizing Rectifiers Krahabors 2001-12-03 00:29:37 UTC Re: [CAD_CAM_EDM_DRO] Sizing Rectifiers Hugh Prescott 2001-12-03 10:22:38 UTC Re: [CAD_CAM_EDM_DRO] Sizing Rectifiers