Re: Is this servo usable for position control?
Posted by
grantfair2001
on 2001-12-05 22:23:52 UTC
--- In CAD_CAM_EDM_DRO@y..., Jon Elson <elson@p...> wrote:
external housing, but it looks as if access to the inside is intended
at one end. But the black lead goes to ground on the control PCB, so
clearly, there was no plan to reverse it with the existing control
electronics. Is there an easy way to determine if it has brushes?
I think <g> .
Grant
> grantfair2001 wrote:pulses can I
>
> > I have 3 Japan Servo DC servomotors . . . If I count the tach
> > use this to establish positions reliably? And control thisthe
> > position with the 24 volts DC supply?
>
> If the tach only has one channel, then you can't determine which way
> motor is going. If that is so, it is not suitable for positioninguse. Are
> theseonly turn
> brush motors or brushless DC. If 2-wire brushless DC, then itwill
>Well, it's a two wire DC motor. I see no sign of brushes on the
> one direction, so that is also useless for positioning
external housing, but it looks as if access to the inside is intended
at one end. But the black lead goes to ground on the control PCB, so
clearly, there was no plan to reverse it with the existing control
electronics. Is there an easy way to determine if it has brushes?
>(unless you never want to go back to where you started from).Would that be a bug, or a feature? With some of my projects, a feature
I think <g> .
> JonThanks very much for your reply.
Grant
Discussion Thread
grantfair2001
2001-12-05 19:06:36 UTC
Is this servo usable for position control?
Tim Goldstein
2001-12-05 19:26:14 UTC
OT PCB group
Jon Elson
2001-12-05 22:01:51 UTC
Re: [CAD_CAM_EDM_DRO] Is this servo usable for position control?
grantfair2001
2001-12-05 22:23:52 UTC
Re: Is this servo usable for position control?
Jon Elson
2001-12-06 09:45:23 UTC
Re: [CAD_CAM_EDM_DRO] Re: Is this servo usable for position control?
captnorm3@j...
2001-12-06 15:15:33 UTC
Re: [CAD_CAM_EDM_DRO] OT PCB group
JanRwl@A...
2001-12-06 18:46:06 UTC
Re: [CAD_CAM_EDM_DRO] OT PCB group
grantfair2001
2001-12-07 17:48:28 UTC
Re: Is this servo usable for position control?
Jon Elson
2001-12-07 21:52:34 UTC
Re: [CAD_CAM_EDM_DRO] Re: Is this servo usable for position control?
grantfair2001
2001-12-07 22:27:52 UTC
Re: Is this servo usable for position control?