Re: CNC FAQ
Posted by
Jon Elson
on 1999-05-21 22:37:38 UTC
Dan Mauch wrote:
G-code and servo systems. I also have a bunch of stuff I've written over
the past few years on Atlas lathes and Bridgeport mills. Most of that is
replies to people's question, but I could search out some of the more general
pieces and put them into some order.
There is an Atlas/Craftsman list, and the metalworking web site has a fAQ,
already. It probably has little specifically on CAD, CAM and EDM.
It does have some pointers and comments about DROs.
Jon
> From: "Dan Mauch" <dmauch@...>I'd be glad to write up some stuff on CNC, especially some of the details of
>
> I can see that in time we will be answering the same questions over and over
> and over again. I think there need to be a FAQ set up so these repetitive
> questions can be answered. That way the focus can remain on developing new
> hardware for the home shops likes Tom's DRO and Jon's .
> Unfortuneately, I don't have the time to set one up. Any volunteers.
G-code and servo systems. I also have a bunch of stuff I've written over
the past few years on Atlas lathes and Bridgeport mills. Most of that is
replies to people's question, but I could search out some of the more general
pieces and put them into some order.
There is an Atlas/Craftsman list, and the metalworking web site has a fAQ,
already. It probably has little specifically on CAD, CAM and EDM.
It does have some pointers and comments about DROs.
Jon