New on EMC: How to set the steps per unit for each axis? for metric
Posted by
natural_born_cadler
on 2001-12-21 09:07:43 UTC
Hello,
New in this gruop and new on EMC i need help on this:
(steppermod. and mm )
I have got EMC BDI installed and running so far.
But i have big problems setting up the right values for the mm units.
As in the faq listet :
"Input would be the number of steps per unit on the stepper motor"
i have following parameters Stepmotor geard : 133.33 steps
(pulses?) for one mm.
I have tried several changes with this value to the *.ini but with no
success. One time i get following errors one time the whole system
chrashes.
Could anybody give me some advise how to set up this value?
greetings,
frank
New in this gruop and new on EMC i need help on this:
(steppermod. and mm )
I have got EMC BDI installed and running so far.
But i have big problems setting up the right values for the mm units.
As in the faq listet :
"Input would be the number of steps per unit on the stepper motor"
i have following parameters Stepmotor geard : 133.33 steps
(pulses?) for one mm.
I have tried several changes with this value to the *.ini but with no
success. One time i get following errors one time the whole system
chrashes.
Could anybody give me some advise how to set up this value?
greetings,
frank
Discussion Thread
natural_born_cadler
2001-12-21 09:07:43 UTC
New on EMC: How to set the steps per unit for each axis? for metric