RE: [CAD_CAM_EDM_DRO] more series I questions
Posted by
Tim
on 2001-12-26 15:13:56 UTC
I would suggest that unless you already have the motors or drives you
consider going to G320/G340 drives and servos. The performance will be
better and the cost will likely be the same or less. I had one bad
stepper on Bridgett (Bridgeport Series II) and did not have 3 G210s yet.
It was cheaper to get 3 surplus servos and sell the 2 good motors than
it would have been to get a replacement stepper.
Tim
[Denver, CO]
consider going to G320/G340 drives and servos. The performance will be
better and the cost will likely be the same or less. I had one bad
stepper on Bridgett (Bridgeport Series II) and did not have 3 G210s yet.
It was cheaper to get 3 surplus servos and sell the 2 good motors than
it would have been to get a replacement stepper.
Tim
[Denver, CO]
> -----Original Message-----
> Hi guys,
>
> I am looking for some suitable Nema 42 steppers for my newly acquired
> series I machine. The machine I purchased didn't come with the
> steppers. In my searching for suitable steppers I have run across
> some Bodine steppers on sale and here are the specs:
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
Discussion Thread
bjapundza
2001-12-26 12:22:42 UTC
more series I questions
Tim
2001-12-26 15:13:56 UTC
RE: [CAD_CAM_EDM_DRO] more series I questions