Re: [CAD_CAM_EDM_DRO] Small, hollow, thick-walled tubing needed

For ultra pressure stuff see:

http://www.highpressure.com/

You will have to download catalog sections but you won't find anything in 3/16"
od. It is kind of an odd size for most all uses Although you will find copper
3/16 od. If you tread stainless milk (even spoiled ) works well as a cutting
lubricant.
Jesse


Jesse Brennan wrote:

> See:
> http://www.accutube.com/.150over.html
> a wall really thick enough to thread may be more difficult. -- The ultra
> high pressure people may have some - but I never worked with any of this less
> than 1/4" . I would suggest a smaller od with a threaded sleeve
> silver brazed on each end. Too small id and surface tension and viscosity
> effects may not let oil drain with only gravity.
> Jesse.
>
>
> > Addresses:
> > FAQ: http://www.ktmarketing.com/faq.html
> > FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> >
> > Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> > Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> > Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> > List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> > Moderator: jmelson@... timg@... [Moderator]
> > URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> > bill,
> > List Manager
> >
> >
> >
> > Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/