Re: [CAD_CAM_EDM_DRO] Re: Kit Difficulity of Camtronics Boards

In a message dated 1/6/2002 3:40:29 PM Mountain Standard Time,
zbadone@... writes:

> Watch for correct polarity of parts, becareful with your soldering, to
> much heat for to long will lift pads from pc board. Watch for solder
> shorts crossing traces, cold solder joints, trim leads when finished
> soldering.
>

I would add to that, to premount the output transistors to there heatsinks,
then solder them in place to insure correct alignment.
bill


[Non-text portions of this message have been removed]