Re: [CAD_CAM_EDM_DRO] using SPC output for 'occasional' closed loop position verification
Posted by
J. Mark Wolf
on 2002-01-16 09:56:01 UTC
Doug Fortune <pentam@...> wrote:
Off list I have been discussing with DaveK
(author of TurboCNC) the possibility of using
SPC (statistical process control - ie serial
bit stream position output devices such as
quill scales and digital readout calipers)
in addition to the normal open-loop software.
Dave
Go, man go! Be sure and let me know if you find the approriate connectors/cables to interface to the caliper scales.
"May a suitable landing spot be always on your glide slope"
J. Mark Wolf, Pinckney, Michigan
Rotorway Exec162F N1955Z
Check out my web site at: www.rotorwaybuilders.net/ucosm
---------------------------------
Do You Yahoo!?
Send FREE video emails in Yahoo! Mail.
[Non-text portions of this message have been removed]
Off list I have been discussing with DaveK
(author of TurboCNC) the possibility of using
SPC (statistical process control - ie serial
bit stream position output devices such as
quill scales and digital readout calipers)
in addition to the normal open-loop software.
Dave
Go, man go! Be sure and let me know if you find the approriate connectors/cables to interface to the caliper scales.
"May a suitable landing spot be always on your glide slope"
J. Mark Wolf, Pinckney, Michigan
Rotorway Exec162F N1955Z
Check out my web site at: www.rotorwaybuilders.net/ucosm
---------------------------------
Do You Yahoo!?
Send FREE video emails in Yahoo! Mail.
[Non-text portions of this message have been removed]
Discussion Thread
Doug Fortune
2002-01-16 07:15:34 UTC
using SPC output for 'occasional' closed loop position verification
J. Mark Wolf
2002-01-16 09:56:01 UTC
Re: [CAD_CAM_EDM_DRO] using SPC output for 'occasional' closed loop position verification