CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] What is the difference between Center Cutting vs Non-Center Cutting EndMills?

on 2002-01-22 10:37:58 UTC
Jon,
Don't listen to Scott... I'll give you .61c each for the Niagara cutters :)

Bryan

-----Original Message-----
From: Scott [mailto:scott@...]
Sent: Tuesday, 22 January, 2002 1:32 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: Re: [CAD_CAM_EDM_DRO] What is the difference between Center
Cutting vs Non-Center Cutting EndMills?


Hey Jon,
If anybody has some in the blue plastic tubes and the tool is a kinda gold
tint to it and the paper label say some Chinese sounding name like Niagara
well I might be talked into giving them $.60 each. (vbg)
Scott


"A number of outlets sell extremely poor quality Chinese-made end mills,
in blue plastic tubular packages, with a paper label. These are horrible
tools, and not worth more than about $0.30 each. The metallurgy is
VERY inferior, and the sharpening looks like it was done by a blind man,
by hand, with a bench grinder! You really want to avoid these tools."




Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/

Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Manager



Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

Discussion Thread

Jon Elson 2002-01-22 09:46:33 UTC Re: [CAD_CAM_EDM_DRO] What is the difference between Center Cutting vs Non-Center Cutting EndMills? Scott 2002-01-22 10:32:07 UTC Re: [CAD_CAM_EDM_DRO] What is the difference between Center Cutting vs Non-Center Cutting EndMills? Gail & Bryan Harries 2002-01-22 10:37:58 UTC RE: [CAD_CAM_EDM_DRO] What is the difference between Center Cutting vs Non-Center Cutting EndMills?