RE: [CAD_CAM_EDM_DRO] Check out AutoEditNC 3.0--NC Code Editor was G02 RX
Posted by
Carol & Jerry Jankura
on 2002-01-27 21:52:01 UTC
Ray:
Try this:
1. Double Click on the URL that's highlighted. This will open Explorer and
open the page
2. While the page is active, click on the 'Favorites' menu
3. Click on 'Add to Favorites'
4. Click on 'OK' button
-- Carol & Jerry Jankura
Strongsville, Ohio
So many toys, so little time....
|----------
|
|http://www.betatechnical.com/autonc.htm
|
|
|
|Addresses:
|FAQ: http://www.ktmarketing.com/faq.html
|FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
|
|Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
|Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
|Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
|List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
|Moderator: jmelson@... timg@... [Moderator]
|URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
|bill,
|List Manager
|
|
|
|Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
|
|
|
Try this:
1. Double Click on the URL that's highlighted. This will open Explorer and
open the page
2. While the page is active, click on the 'Favorites' menu
3. Click on 'Add to Favorites'
4. Click on 'OK' button
-- Carol & Jerry Jankura
Strongsville, Ohio
So many toys, so little time....
|----------
|
|http://www.betatechnical.com/autonc.htm
|
|
|
|Addresses:
|FAQ: http://www.ktmarketing.com/faq.html
|FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
|
|Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
|Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
|Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
|List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
|Moderator: jmelson@... timg@... [Moderator]
|URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
|bill,
|List Manager
|
|
|
|Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
|
|
|
Discussion Thread
wanliker@a...
2002-01-27 13:26:26 UTC
Check out AutoEditNC 3.0--NC Code Editor was G02 RX
Raymond Heckert
2002-01-27 21:09:37 UTC
Re: [CAD_CAM_EDM_DRO] Check out AutoEditNC 3.0--NC Code Editor was G02 RX
Carol & Jerry Jankura
2002-01-27 21:52:01 UTC
RE: [CAD_CAM_EDM_DRO] Check out AutoEditNC 3.0--NC Code Editor was G02 RX