CAD CAM EDM DRO - Yahoo Group Archive

connection of ground pins

Posted by dodge1320
on 2002-01-31 22:08:53 UTC
When wiring up my driver board, pin 25 connects to ground. Pins 18-25
are all grounds, right? Should I solder them together? I have had
problems like a/c, that occasionally cause the motors to lose steps
and chatter, but I do not have a scope to check this out. Thanks Rick

Discussion Thread

dodge1320 2002-01-31 22:08:53 UTC connection of ground pins Chris L 2002-02-01 05:13:58 UTC Re: [CAD_CAM_EDM_DRO] connection of ground pins JanRwl@A... 2002-02-01 11:26:01 UTC Re: [CAD_CAM_EDM_DRO] connection of ground pins