Z-axis installed and it works!!!
Posted by
jeffdavis516
on 2002-02-02 15:48:45 UTC
I just finished installing my Z-axis CNC design into my Enco
drill/mill. This axis was the only part of my CNC retro that I was
not %100 sure it would work. After my installation I wired it to the
Gecko servo controller and started up CNCPro. Set rapid jog to 100
in/min and pushed the jog key and it MOVED!! down and up with no
problems.
I only have two more parts to make and then I can install the X and Y
axis. Won't be long and I will be CNCing :)
Jeff
http://www.homecnc.info
drill/mill. This axis was the only part of my CNC retro that I was
not %100 sure it would work. After my installation I wired it to the
Gecko servo controller and started up CNCPro. Set rapid jog to 100
in/min and pushed the jog key and it MOVED!! down and up with no
problems.
I only have two more parts to make and then I can install the X and Y
axis. Won't be long and I will be CNCing :)
Jeff
http://www.homecnc.info