Re: Lowering Gecko Voltage
Posted by
garyswindell
on 2002-02-19 16:30:17 UTC
The actual voltage to the piezo is around 500V the controller board
needs the 10V input and it takes care of stepping it up.
needs the 10V input and it takes care of stepping it up.
--- In CAD_CAM_EDM_DRO@y..., "studleylee" <indigo_red@q...> wrote:
> I agree op amps( with beefed output stages) would do better for
> precise positioning with piezos, but now he's got to design the amp.
>
> Also what piezo motor only needs +/- 10 volts. Is this going direct
> to the 'crystal' or is there a drive involved that is contolled by
> the +/-10v that you wish to produce from a Step.Dir controller.
>
> Not an expert on piezo positioners, just tossing out ideas.
> -Lee
>
Discussion Thread
garyswindell
2002-02-19 08:12:02 UTC
Lowering Gecko Voltage
studleylee
2002-02-19 10:54:43 UTC
Re: Lowering Gecko Voltage
ccs@m...
2002-02-19 11:20:33 UTC
Re: [CAD_CAM_EDM_DRO] Re: Lowering Gecko Voltage
Bill Vance
2002-02-19 11:41:41 UTC
Re: [CAD_CAM_EDM_DRO] Lowering Gecko Voltage
mariss92705
2002-02-19 14:07:19 UTC
Re: Lowering Gecko Voltage
studleylee
2002-02-19 14:56:44 UTC
Re: Lowering Gecko Voltage
garyswindell
2002-02-19 16:30:17 UTC
Re: Lowering Gecko Voltage
mariss92705
2002-02-19 17:05:55 UTC
Re: Lowering Gecko Voltage
garyswindell
2002-02-20 11:55:33 UTC
Re: Lowering Gecko Voltage