Re: [CAD_CAM_EDM_DRO] Motor woes

Paul

Whereabouts in Cheshire are they situated?

----- Original Message -----
From: "Paul" <Paul.Corner@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Monday, March 18, 2002 7:32 PM
Subject: Re: [CAD_CAM_EDM_DRO] Motor woes


>
> Hi Steve
>
> Just caught up with the weekend's emails - Not sure if this has been
> mentioned to you before, but Colin Baker has a load of steppers and bits
> going at a reasonable price. He is up in Cheshire, which is closer to home
> than some of the folks on the CCED list.
>
> Attached is a snippet from a recent email of Colins's.
>
> Regards, Paul.
>
>
> On Friday 15 March 2002 23:35, Steve Blackmore wrote:
> > Can anybody recommend some reasonably priced size 23 motors available
> > in the UK - I'm looking for between 5-7Kg-cm holding torque, but with
> > a reasonable turn of speed.
>
> --------------------------------------------------------------------------
-----------------
>
> From: "RachelBarker" <rachel@...>
> To: <cad_cam_edm_dro@yahoogroups.com>
>
> Hello Everyone.
>
> I run a small engineering company in the UK which builds special purpose
> machines for the pcb industry.
>
>
> Frame size 23, 2 stack steppers ( 1 nm) made by Sanyo. QTY- I've lots.
> 20.00 each (No. 37)
>
>
> HP rotary encoders. Part No. HEDL-5640
> QTY - 10 7.50 each
>
> Various glass scales.
> 1.3 m travel. 500mm travel 150mm travel
> QTY - Several 25.00 each (No.41)
>
>
> Colin Barker
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://www.jobshophomeshop@yahoogroups.com I consider this as a sister
site to the CCED group, as many of the same memembers are there, for OT
subjects, that are not allowed on the CCED list.
>
>
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>