Is it possible to make an add on chopper circuit?
Posted by
racingjewels
on 2002-03-19 19:05:54 UTC
Hi ,
I have a 3 axis unipolar control that is being set up for 4 amp/phase
motors @ 3.6 volts... Is there a simple to build chopper circuit
that can be added on in place of the large resistors that I may need
to use ... I was planning on using this control system to test a
variety of cnc systems with motors that range from 1 amp to 4
amps /phase ... Doing this with resistors Would require more work
than it's worth.
Is this possible and would anyone have a chopper circuit diagram/
plan that may work?Or, Am I totally off my rocker :-)
Thanks for any info or help.
Daniel
I have a 3 axis unipolar control that is being set up for 4 amp/phase
motors @ 3.6 volts... Is there a simple to build chopper circuit
that can be added on in place of the large resistors that I may need
to use ... I was planning on using this control system to test a
variety of cnc systems with motors that range from 1 amp to 4
amps /phase ... Doing this with resistors Would require more work
than it's worth.
Is this possible and would anyone have a chopper circuit diagram/
plan that may work?Or, Am I totally off my rocker :-)
Thanks for any info or help.
Daniel