RE: [CAD_CAM_EDM_DRO] EMC configuration
Posted by
Tim Goldstein
on 2002-03-24 15:00:36 UTC
If you are using steppermod.o it is the INPUT_SCALE. If you are using
freqmod.o then it is both INPUT_SCALE and OUTPUT_SCALE.
Tim
[Denver, CO]
sister site to the CCED group, as many of the same memembers are there,
for OT subjects, that are not allowed on the CCED list.
freqmod.o then it is both INPUT_SCALE and OUTPUT_SCALE.
Tim
[Denver, CO]
> -----Original Message-----http://groups.yahoo.com/group/jobshophomeshop I consider this as a
> From: Scott Hendershot [mailto:scott@...]
> Sent: Sunday, March 24, 2002 3:36 PM
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: [CAD_CAM_EDM_DRO] EMC configuration
>
>
> I have finally gotten EMC up and running. I am using stepper
> motors and not servos. Where do you configure the number of
> steps/mm? Is it the output scale? I can't really tell from
> the documentation.
>
> TIA
>
> Scott
>
>
> [Non-text portions of this message have been removed]
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
> aol://5863:126/rec.crafts.metalworking or go thru Google.com
> to reach it if you have trouble.
> http://www.metalworking.com/news_servers.html
>
sister site to the CCED group, as many of the same memembers are there,
for OT subjects, that are not allowed on the CCED list.
Discussion Thread
Scott Hendershot
2002-03-24 14:36:11 UTC
EMC configuration
Tim Goldstein
2002-03-24 15:00:36 UTC
RE: [CAD_CAM_EDM_DRO] EMC configuration