CAD CAM EDM DRO - Yahoo Group Archive

Re: Question for Mariss about G201

Posted by mariss92705
on 2002-03-30 13:46:52 UTC
Hi,

Not a problem. The drives first get tested with no motor attached. If
they pass that filter with everything running properly, then the
motor is connected for final test. Just don't connect or disconnect
the motor while the drive is powered up.

Mariss

--- In CAD_CAM_EDM_DRO@y..., "rsgoldner" <rgoldner@i...> wrote:
> Is it ok to power up a G201 without a motor connected?
>
> TIA!

Discussion Thread

rsgoldner 2002-03-30 12:13:44 UTC Question for Mariss about G201 mariss92705 2002-03-30 13:46:52 UTC Re: Question for Mariss about G201