Re: [CAD_CAM_EDM_DRO] Vexta Steppers / gearheads help needed........

Posted by RC

on 2002-03-31 17:33:01 UTC

Thank for the info, not sure if I will need that scan, but what are you
using you vexta stepper for?

Russ

----- Original Message -----
From: Alan Marconett KM6VV <KM6VV@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Sunday, March 31, 2002 4:34 PM
Subject: Re: [CAD_CAM_EDM_DRO] Vexta Steppers / gearheads help
needed........

> Hi Russ,
>
> I have PH266-01GK Vexta steppers. They are about 83 oz/in. My attached
> gearboxes are 2GK7.5KA. I have a data sheet for the gear boxes and the
> steppers, mostly Japanese. and I see 50 ~ 180 as a "reduction ratio". I
> can scan and send you the data sheet, perhaps you'll make more of it
> then I did! I think the simplest method of determining the gear ratio
> is just to drive it, and count the rev's! The motor data sheet did not
> say the torque. The motor plate says 1.8 degree, 6V, 1.2A
>
> Let me know if you want the scans, about 2.3M each!
>
> Alan KM6VV
>
>
> RC wrote:
> >
> > Does anyone know the specs or where I could find information on Vexta
stepper mod. #ph266-ogk, information needed work be holding torque, and on
the attached gearhead, information needed would be the gear ratio.
> >
> > Thanks,
> > Russ
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this as a
sister site to the CCED group, as many of the same memembers are there, for
OT subjects, that are not allowed on the CCED list.
>
>
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>

Discussion Thread