Re: software

Here is a website I thought some of you may be
interested in,

http://www.metacut.com/

Steve



----------
From: Ian Wright <Ian@...>
To: CAD_CAM_EDM_DRO@onelist.com
Subject: Re: [CAD_CAM_EDM_DRO] RTL linux
Date: Sunday, December 19, 1999 7:37 AM

From: "Ian Wright" <Ian@...>

Charles,

If you are still booting to the old kernel, have you set up lilo or
whatever
boot prog you are using to know that the new kernel exists? If you are
using
lilo, you need to add a bit into the script pointing it to the new kernel
and then run /sbin/lilo (or wherever lilo lives in Slackware). I don't know
Slackware, but if it has anything comparable to 'linuxconf' then this will
give an easier method of setting up boot parameters.

Ian
--
Ian W. Wright
Sheffield UK

----- Original Message -----
From: Charles Hopkins <chopkins@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: 19 December 1999 01:01
Subject: [CAD_CAM_EDM_DRO] RTL linux


> From: Charles Hopkins <chopkins@...>
>
> I am running Slackware linux and would like to install the RTL Patch. I
also will be installing EMC, but can't get past the RTL.
>
> I get the patch to work fine. I changed the version number in the
kernel_patch file which is created from the tar before I ran the patch.
The
patch appears to work fine.

Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
To Unsubscribe, read archives, change to or from digest.
Go to: http://www.onelist.com/isregistered.cgi
Log on, and you will go to Member Center, and you can make changes there.
For the FAQ, go to http://www.ktmarketing.com/faq.html
bill,
List Manager